7
WARNING
CHOKING HAZARD!
Ensure that the
fi
replace
area is clear of
fi
re glass, vermiculite or shale
particles as these could be ingested by small
children. Vacuum thoroughly around the
fi
replace
area after cleaning.
WARNING
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fireplace front
after maintenance.
!
applied to the surface, no alcohol/solvent based clean-
ing agents nor polishes should be used. Dry stains can
be removed using a white or light colored cloth with mild
soap and warm water when the material is cool, then
dried immediately. If the stain is hard to remove, use a
white or light colored synthetic scrub pad (not steel wool)
and dry immediately. In case of an accidental spill, soak
up the liquid
IMMEDIATELY
with a dry cloth and follow
up with a wipe down with a wet cloth.
Clean the barrier screen
dusting it with a soft brush.
Clean the
fi
rebox
ceramic logs/rocks and walls dust-
ing them with a soft brush. Dust can also be removed
from the burner using a soft brush after removing the
ceramic logs.
When cleaning, make sure that no par-
ticles are brushed into the slots of the burner.
To re
fi
t the window:
1. Place the window in its bottom railing.
Ensure to
remove any vermiculite or glass particles in
the railing before installing the window.
2. Push the top of the window frame against the
fi
rebox.
Owner’s Information
!
Hot Glass Warning Plate
Window frame
Bottom railing
3. While you hold it, pull and hook the side levers back
to the window brackets on each side.
4. Apply light hand pressure against the window frame
sides to bed-in the window seal.
5.
If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
DANGER
To ensure a safe operation, verify that the levers
are hooked properly to the window tabs; then,
pull out the top of the window and release it to
insure the springs return it.
Also, double-check that the bottom of the
window frame is correctly installed in its the
bottom railing.
!
Failure to install window correctly can damage
components, cause overheating resulting in
dangerous conditions. Damage caused by
incorrect window installation is not covered
by the Valor warranty.
1
2
3
OWNER’S
INFORMATION