39
Installation
Liners
6. Place rear panel’s centre section on the ledge be-
hind the tabs, slide it to the right so that its stepped
edge
fi
ts into the stepped edge of the rear panel’s
right section.
7. Place the left side panel against the left
wall of the
fi
rebox.
8. Tighten the side panel anchors on each
side of the
fi
rebox
9. Place the remaining rear panel’s section behind
the left side panel and
fi
t its stepped edge to the
stepped edge of the rear panel’s center section.
10. Carefully lift, slide and position top panel on to left
side and rear panel.
NOTE: If gapping occurs between each section of
the rear panel, a lift tab located on each end of
ledge can be bent by hand to close the gap.