32
Fuel Beds
Installation
A black discoloration may form over time at
the front bottom of the 6-rock original fuel
bed; this deposit can be burned o
ff
by running
the
fi
replace on a low to medium setting
fi
re
for 30 to 45 minutes. This discoloration is
unavoidable and will re-form again.
Rock
identi
fi
cation
Triangular
hole in
ceramic base
All rocks installed
4. The underside of each ceramic rock is identi
fi
ed
by a number and a speci
fi
c protruding locating
triangle.
Install the six rocks from left to right starting
with rock no. 1.
Note that the ceramic base may need to be
slightly adjusted side-to-side to allow stones to
fi
t within the platform.
5. Place the glass panel in its cavity formed by the
front support and the ceramic platform.
6. Place the left twig across the sec-
ond and thirs rocks from the
left
;
rest its end on the glass near the
edge of the platform as shown.
Ensure to leave a gap between
the twig and the
fi
rst rock to allow
fl
ame to
come up between the twig and the rock.
7. Place the right twig across the
second and third rocks from the
right
; rest its end on the glass
about 1 cm (13/32”) from the edge
of the platform as shown.
Ensure
to leave a gap between the twig and the
fi
rst
rock to allow
fl
ame to come up between the
twig and the rock.
