24
Appliance Preparation
Install Top Heat Shield & Stand-o
ff
s
1. If installing appliance with top vent outlet,
remove the plate covering the vent hole in the top
heat shield by unscrewing four screws.
If installing
with rear vent outlet, the plate must remain to
cover the hole.
2. Remove the screws at the top rear corner of the
case sides.
3. If top vent outlet, locate the heat shield over the
vent pipe adapter.
4. Support the front of the shield on the two angle
supports.
5. Secure the shield to the case sides by re
fi
tting the
two screws at the top rear corners and by two
screws from the pack
fi
tted near the front.
6. Bend the two top rear stand-o
ff
s and
fi
t to the heat
shield with three screws each.
Install Support Angles
The distance from the wall angles to the front face of
the heater case is adjustable between 3/8 inch and
1-3/16 inch to allow for a range of wall
fi
nish material
thickness (e.g. tile, etc.).
NOTE: When adding optional fronts and trims, it is
important to install heater
fl
ush or slightly recessed into
the
fi
nished
wall surface.
1. Fit the top angle support to the case top (3 screws).
2. Fit the two side angle supports (2 screws each). Fit
the screws from inside the heater case.
Remove Rear Log Support
Remove the rear log support to access to the rear
ori
fi
ces for restrictors installation (5 screws).
Top & rear stand-o
ff
s
Remove rear support—logs only
Wall finish material
thickness (tile, etc.)
3/8” - 1-3/16”
(10-30 mm)
Fit screws
from inside
case
Shield to rest
on 2 supports
Push shield
forward
Heat shield
(shown for top vent outlet)
Support angles
Heat Shield & Stand-offs
NOTE
Zero clearance stand-offs and shield supplied with
the appliance are not required for the co-linear
applications.
