Valor GV60BRK, Инструкция по установке и эксплуатации, Страница: 2 / 10

2
Remote Control Operation
Radio Frequency
315 MHz for USA and Canada.
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: Before using the remote control system for
the first time, the receiver and the handset must
be synchronized. See the section Synchronize Remote
Control on page 1 .
IMPORTANT: BEFORE YOU BEGIN, please note that on this
system, the settings of time, temperature and automatic
ON/OFF can only be programmed when the function
display is flashing . Be patient when programming as it can
take a few seconds to set.
Note: In the TEMP or TIMER modes, the remote handset
senses the room temperature and adjusts the flame
accordingly.
To communicate, the handset should be within 15 feet
(4.5 meters) of the fireplace.
Do not leave the handset on the mantel or hearth.
SET (scrolls through
modes and settings)
OFF (returns to set mode,
turns the burner and
WKHSLORWR΍
/DUJHȵDPHEXWWRQȵDPHV
up, sets hours, temperature)
6PDOOȵDPHEXWWRQȵDPHV
GRZQDQGR΍VHWVPLQXWHV
temperature)
Current
temperature
(F or C)
Current time
(12 or 24 hour clock)
Modes (Manual,
Temperature, Timer)
Handset
sensor
Battery status
Current
programmed
period (Timer)
Period
start or end
(Temp, Timer)
Turn Fireplace ON
Press + buttons until you hear a
short beep; release buttons.
Beeping continues until pilot is lit.
Burner lights to maximum flame height
and handset goes automatically to
manual (MAN) mode.
NOTES:
On the valve, MAN button must be at ON, in full counter-
clockwise position .
ON/OFF switch (if equipped) must be in I (ON) position.
Turn Fireplace OFF
Press button.
When pilot is just turned off, wait 2
minutes to light it again.
Standby Mode (Pilot Flame)
Press and hold to set fireplace
to pilot.
Adjust Flames Height
With pilot lit, press and hold buttons:
= increase flame height
= decrease flame height or
set to pilot
For fine adjustment, tap buttons.
Express Low and High Fire
Double-click buttons:
= increase flame to maximum
height “HI”
= decrease flame minimum
height “LO”
NOTE: Flame goes to high fire first before
going to designated low fire.
x 2
x 2