the “V” shaped brackets near the bottom
front sides of the convection box (see
figure 10).
5.7
Place the convection box fully back into
the fireplace opening so that it is sealed
against the fireplace front surround.
5.8
Fit a cable retainer over the bottom end of
each cable (see figure 10).
5.9
Pull each cable taut. Push the cable
retainers hard up against the “V”
brackets.
Tighten the screws in the retainers so that
they clamp the cables in position. Apply
tension to the cables by turning the
hexagonal adjusters by hand
(see figure 10).
5.10
Inspect the installation of the convection
box against the fireplace surround. If the
convection box is aligned squarely and
the sealing is satisfactory, fully tighten the
cable retainers.
5.11
If the convection box is not correctly
aligned, release the tension on the cables
by slackening the screws and turning the
hexagonal adjusters fully anticlockwise.
The convection box should then
automatically realign itself. Pull each cable
taut again and push the cable retainers
back against the “V” brackets. Again,
tighten the screws in the retainers and
apply tension to the cables by turning the
hexagonal adjusters clockwise as far as
possible.
5.12
Store the free length of the cables in
convection box. This will allow easy
removal and refitting of the appliance
during subsequent service calls.
5.13
Using the floor sealing tape supplied, seal
the bottom of the convection box to the
fireplace and hearth floor (see figure 11).
Make sure that the whole length of the
front edge of the convection box is fully
sealed.
6.1
Refit the burner unit to the convection box
with two screws. Make sure that the
tab at the right side of the battery box is
in front of the “L” shaped bracket which
projects up from the fire case base.
See figure 11A.
6.2
Reconnect the slider control linkage firmly
to the burner control pivot with the
shouldered screw using a screwdriver
(Not finger tight only).
Page 9
INSTALLER GUIDE
6.BURNER & FASCIA
INSTALLATION
figure 10
Cable retention arrangement
figure 11
Floor sealing
figure 11A
Burner fitting
Valor 600B610_01 7/12/00 3:22 PM Page 9
