13
10.6
Place the rear left coal (embossed 'E' underneath) in position as shown
in figure 15.
10.7
Replace the window unit and tighten the 12 wing nuts.
11
CHECK APPLIANCE OPERATION
11.1
Turn on the gas supply and check all joints up to the appliance gas tap for gas soundness using a soap solution or
leak detection fluid.
11.2
Depress the control knob. While keeping it depressed, turn to IGN position. Turning the control should
normally cause two consecutive sparks to occur between the pilot hood and the electrode pin which should ignite the pilot
gas.
The pilot flame can be seen by looking through the gap at the front of the right side front coal.
If the pilot does not ignite, keep the knob depressed for a few seconds to purge air from the supply pipes, then, turn back to
OFF and repeat the ignition procedure.
11.3
When pilot ignition has been achieved, keep the control knob depressed for a few seconds then release it. If the
pilot does not remain alight ensure that the air has been purged.
11.4
Partially depress the knob and turn to position 1. Both main and decorative flame burners should light at the
lowest setting. The decorative flames should just be visible. If the decorative flames are visible, the main burner must be
alight since it lights the decorative burner.
11.5
Turn the control knob gradually to MAX position. Both burners should gradually increase in output until at
MAX position the main burner is at its greatest heat output and the decorative flames are at their full magnitude.
11.6
Turn back to off after checking.
Depress the control knob partially, turn clockwise to OFF and release the knob. If any resistance is felt when turning,
release the downwards pressure on the knob before continuing to turn.
Fig. 15 Rear Left Coal “E” Location
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - [email protected] 0844 556 1818
