18
Installation
Liners
Install Liner Panels
The following guidelines apply to all panels except
706RGL Re
fl
ective Glass Liners for which separate
instructions are provided with the kit. You do not need
to remove the burner to install the panels.
1. Inside the
fi
rebox, on the top of each side, release
the screw of the side panel anchors (one per side)
just enough to allow them to rotate.
Remove and re-install burner (if necessary)
The ceramic panels can be installed without removing
the burner. However, you can remove the burner for
additional space if desired.
1. Remove the screw
fi
xing the rear of the burner to
the manifold bracket as indicated.
2. Grab the burner and gently pull up the rear
fi
rst
while pushing back and unhooking the front tabs
from their retaining lances.
Be careful not to hook
the pilot hood as you pull the burner up.
3. To reinstall the burner,
fi
t the
burner in the
fi
rebox insert-
ing the front tabs
fi
rst in the
lances.
Note: Ensure that the front
of the burner is well hooked
when re-installing!
Again, be careful not to
hook the pilot hood when
fi
tting the burner over the pilot.
4. Fix the burner to the manifold bracket at the rear
with screw.
Screw
2. Place the rear panel against the back of the
fi
rebox,
on the ledge at bottom, behind the burner.
3. Rotate the anchor up and out of the way and slide
the left hand side panel against the
fi
rebox side.
Rotate the anchor back down to hold the panel.
4. Rotate the anchor up and out of the way and slide
the right hand side panel against the
fi
rebox side.
Rotate the anchor back down to hold the panel.
5. Tighten the side panel anchors on each side of the
fi
rebox.
6. Install the top panel supporting it with the back and
side panels.
7. Discard the front bricks as they are not required on
this
fi
replace.
