Page 3 of 5
•
Remove the metal between the two cutouts in
the side of the linerbox.
(Fig.5)
•
Secure the control mounting bracket to the
battery heat shield(see fig 6)
•
Connect the Molex connector from the fan to
the control box, feed the cord set through the
left-hand side of the liner box, and then secure
the control box and the control heat shield to
the mounting bracket ( see fig 7)
•
On the burner module, drill a 1/8” hole on the
burner tray approx 1” from the front.(see fig 8)
•
Place the burner module back in engine and
secure the thermal switch ( see fig 9).
•
If the fireplace is installed as an insert, route the
cord directly across the hearth on the left side,
away from the fireplace. Do not attempt to
route the cord behind, in front of or over the
liner box as damage to the cord may result in
an electrical hazard.
•
Re assemble the fireplace.
•
The fan and controls are factory tested to
ensure the fan operation but, with the control
box energized, check that the fan operates
correctly.
The unit must be hot to do this.
fig.5
fig.6
fig.7
fig.8
fig.9
f i r e - p a r t s . c o m
