Valor 650JN, Инструкция по установке и эксплуатации

Страница: 14 / 54

14 14
Remote Control Operation
Wall Switch Operation
AUTOMATIC TURN DOWN
AUTOMATIC SHUT OFF
LOW BATTERY INDICATION
HANDSET / RECEIVER MATCH
Remote handset: The battery icon will show when
the battery needs to be replaced.
Replace with one 9 V
alkaline battery.
Receiver: Frequent ‘beeps’ for 3 seconds when the motor
turns indicate the batteries need to be replaced. Replace
with four 1.5 V
alkaline batteries.
The remote control handset and receiver are program-
med to function together. In case of a replacement of the
handset or the receiver, you will need to reset the receiver
to allow them to function together. Contact your dealer for
details.
• No communication. If there is no communication
between the receiver and the handset for a period of 6
hours, the appliance goes into pilot mode.
• No change in fl ame height. If there is no change
in fl ame height for a period of 6 hours, the appliance
goes into pilot mode.
NOTE: In TEMP or TIMER modes, the fl ame height
will vary according to room temperature. The appliance
will continue to work normally. However, if the room
temperature remains the same for 6 hours, the appli-
ance will go into pilot mode.
• Low batteries in the receiver. With low battery power
in the receiver the system shuts off completely.
NOTE: This does not apply when the power supply is
interrupted.
• No change in pilot. The appliance shuts off
completely when it is continually in pilot position—
without any change—for a period of 5 days.
Timer Programming Example (default temperatures shown)
6:00 a.m.—
P
1
Start time
4:00 p.m.—
P
2
Start time
6:00 a.m.—
P
1
Start time
8:00 a.m.—
P
1
End time
10:00 p.m.—
P
2
End time
Set temp 74 ˚ F Set temp 40 ˚ F Set temp 74 ˚ F
Set temp 40 ˚ F
☼ ☼
☼
☼
☼
☽ ☽
☽ ☽
CAUTION
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the battery box or the
handset! This could cause a short circuit.
TO TURN APPLIANCE ON and OFF
TO ADJUST FLAME HEIGHT
• Press ON-OFF button once to light
pilot. Press again to shut of pilot.
• Press and hold large fl ame
button to gradually increase
fl ame height.
• Press and hold small fl ame
button to gradually decrease
fl ame height.
The Wall Switch can be used to
control your
fi replace. You can
turn the pilot on or off and you can
increase or decrease the
fl ame
height.
Note that the thermostat and
programming functions are not
available with the wall switch.
OWNER’S
INFORMATION