OWNER’S GUIDE
Page 8
Figure 2. The Control
3.
If low heat is required, release the button.
The button will automatically spring up to the
low heat position shown in figure 2 (See note
i below).
4.
For a higher heat level slide the button
upwards. The burner flames and heat output
will gradually increase until the button
reaches the high heat position shown in figure
2. When the button reaches the high heat
position you will feel a check to its
movement.
Do not
slide the button above
the high heat position unless you want to
turn the fire off
(See note i below)
.
Note i) If the flames go out while setting
the control, repeat the full lighting
procedure. If the flames repeatedly
go out have the fire serviced.
ii) Please note. When first turned on
the flames will appear
predominantly blue. The coals will take time to warm up. Although some glow
will be seen after approximately ten minutes, the full visual effect will only be
apparent after a somewhat longer time.
iii) The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply slide the
control button to its highest setting. This will also burn off any carbon deposits
that may have formed during previous operations.
iv) If operating the appliance for long periods it is beneficial occasionally to
change the settings. This will also help
to remove any carbon deposits that
may form during operation.
To turn the fire off
Slide the button up past the high heat position to the “
O
” position.
Both the main burner and the pilot should go out.
While cooling, the coals may make some crackling noises. This is quite normal.
