OWNER’S GUIDE
Page 8
Figure 3 Colourway & Homestyle
Controls
Figure 4 Pilot flame
To Turn Off the Main Burner and Pilot
•
Turn the right hand control knob to the pilot position marked . Push the knob in at
this position and turn to the off position marked
•
.
Model 5401 Colourway & 5402 Homestyle
The controls are shown in figure 3.
To light the pilot
•
Push in the right control knob (the pilot
lighting knob) and, while keeping it depressed,
turn anticlockwise through the ignition
position marked and up to the pilot
position marked . The spark should light
the pilot. The pilot flame can be seen by
looking through the gap near the left side of
the coal front (See figure 4).
•
When the pilot has lit, keep the right hand
control knob depressed for a few seconds to
prevent the flame supervision device from shutting off
the gas supply while its probe warms up, as explained
above, then release it. If the pilot does not remain alight
turn the knob back to the off position marked
•
.
Wait a
few seconds and repeat the lighting sequence.
To Light the Main Burner
•
Partially depress the right control knob and turn to the
main burner position marked .
•
The main burner flames are controlled by using the
rocker switch at the right side of the fire case. Operating
the rocker switch automatically causes the knob at the left side of the pilot control knob
to rotate. Pressing in the top half of the switch turns the main burner on. Keeping the top
half pressed gradually increases the flame height and heat output. Pressing the bottom
half reduces the flame height and heat output and finally turns the main burner off. In the
unlikely event of failure of the rocker switch, the left side knob can be turned manually.
To Turn Off the Main Burner Only
•
Press in and hold the bottom half of the rocker switch until the main burner is
extinguished. Alternatively, the main burner can be extinguished by turning the right
hand control knob to the pilot position marked .
To Turn Off the Main Burner and Pilot
•
Turn the right hand control knob to the pilot position marked . Push the knob in at
this position and turn to the off position marked
•
.
