Valor 1600IN, Инструкция по установке и эксплуатации

Страница: 45 / 64

45
Installation
Installed tray
Edge of tray fl ush
with edge of fi rebox
Small round
hole at rear
left of
fi rebox
Top
Bottom
Install Decorative Glass Set 1500DGS
Material required
• Middle platform brackets (supplied with set)
• Small container to distribute
fi reglass (not included)
• Decorative Glass Set, which contains:
◊ 3 bags of crushed glass
◊ 1 metal tray for glass
IMPORTANT: Approved for use only with the fi reglass
provided with your Valor fi replace or the fi reglass
brands
American Fireglass
™ or
fi regear
. The use of
any other fi reglass products may void your fi replace
warranty.
Installation
Carefully unpack the kit. To install this kit, the burner
must be removed to
fl ip the platform supports under the
burner.
1. Remove the screw at the right end of the burner.
2. Slide the burner to the right to disengage it from the
ori fi ce and lift it out of the fi rebox.
3. Remove the two platform supports (2 screws each),
fl ip them upside down and secure them back with
the same screws.
4. Re-install the burner locating its left end within the
burner support and sliding the burner to the left
while centering it onto the injector elbow. Fix the
burner support screw at the right end of burner to
the burner support
while pushing the burner to left to
ensure tight fi t against the gasket
.
5. Install both middle platform brackets in front of and
behind the burner, with the tabs downward, the tabs
inserted into the slots of the platform supports as
indicated.
6. Install the metal tray on top of the brackets as
indicated. The tray, when installed properly, is fl ush
with the front edge of the fi rebox opening. As well,
the small round hole in the tray should be at the rear
left when facing the
fi rebox.
Remove screw
Remove burner from fi rebox
Before
bracket profi le bracket profi le
After
QUALIFIED
INSTALLER