2
Considerations
We highly recommend installing this fan (blower) kit to
the appliance before completing the installation of the
appliance otherwise the gas line must be disconnected
and the burner module removed from the firebox to
gain access to the blower area.
If installing this fan after the fireplace installation has
been completed, remove the following components
using the fireplace installation manuals provided with
the fireplace:
• Disconnect the gas line from the appliance at the
appliance valve.
• Barrier screen, trim side doors, trim plinth, plinth
support, window, fuel bed, fuel bed platform.
NOTE: Electrical wiring should be already installed
inside the appliance case. An electrical supply to the
control module is required to power this optional fan.
Installation Components Required
1595CFKV2—Circulating Fan Kit, containing:
• Fan unit (motor and housing)
• Fan mounting plate
• Thermal
switch
• Power cable with Molex connector
• Wiring diagram label
• Sheet metal screws (2)
GV60VM—V-Module Kit
(sold separately)
,
containing:
• V-Module - relay box
• Receiver to relay cable
• Power cord assembly with plug
BLOWER
BLOWER
JUNCTION BOX
WITHIN FIREPLACE
GND
RECEIVER TO RELAY CABLE #4002531 SUPPLIED
SEPARATELY WITH FAN CONTROL MODULE
3-PIN MOLEX
POWER CORD,
37” LONG
#4007877
POWER CORD ASSEMBLY
#4006350 SUPPLIED
SEPARATELY WITH FAN
CONTROL MODULE
REMOTE CONTROL
RECEIVER
SHIPPED WITH
FIREPLACE
NOTE - ALL WIRING IS SPECIFIC TO THIS KIT
AND SHOULD ONY BE REPLACED WITH
ORIGINAL EQUIPMENT WIRING FROM THE
MANUFACTURER.
FAN CONTROL MODULE
#4002530
(SUPPLIED SEPARATELY)
MOLEX
CONNECTORS
CIRCULATING FAN KIT
120 VAC, 60HZ, LESS THAN 1 AMP
MANUFACTURED BY
MILES INDUSTRIES LTD
NORTH VANCOUVER, CANADA
4007878-01
MODEL 1595CFKV2
THERMAL SWITCH
GROUND WIRE, BLOWER HOUSING
TO STUD ON MOUNTING PLATE
Fan unit
Fan mounting plate
Thermal switch
Power cable
Sheet metal
screws (2)
Wiring diagram
and label
1595CFKV2
GV60VM
(sold separately)
V-Module
relay box
Receiver to
relay cable
Power cord assembly
