6
WARNING
DO NOT TOUCH THE GLASS WHILE IT IS HOT!
Let the
fi
replace cool
fi
rst before cleaning it.
!
Spring Loaded
Window Levers
Cleaning
Important - Glass cleaning - Mineral deposits
One of the by-products of the combustion process in
a gas appliance is a mineral which can show up as a
white
fi
lm on the ceramic glass of the viewing door.
The composition of the deposit varies with location and
time. It is believed to be associated with the varying
sulfur content of the gas. You may have the problem
intermittently.
We have consulted with ceramic glass manufacturers
and they cannot offer a de
fi
nitive solution to this prob-
lem. Dealers have tried various cleaning products with
varying results. The following are recommendations
only and are not meant to guarantee results.
NOTE: This is a problem beyond Miles Industries’
control and is not covered under warranty.
• Clean the glass regularly as soon as you notice
the buildup (white
fi
lm). If the
fi
lm is left for a longer
period of time, it will etch into the glass. It is then
much harder, if not impossible, to remove.
• NEVER use an abrasive cleaner on the
ceramic glass.
Any abrasion of the surface
has the immediate effect of compromising the
strength of the glass. An emulsion type cleaner is
recommended.
• Use a soft damp cloth to apply the cleaner. Dry the
glass with a soft, dry, preferably cotton cloth. Most
paper towels and synthetic materials are abrasive to
ceramic glass and should be avoided.
• Our dealers have had good results from the
products listed below. We cannot, however,
guarantee the results of these products.
◊
Brasso, Polish Plus by Kelkem, Cook Top Clean
Creme by Elco, White Off by Rutland, Turtle Wax
Do not clean the glass while it is hot.
Always
securely replace the window before lighting.
If broken,
the glass pane may only be replaced as a complete
window unit as supplied by the manufacturer.
Owner’s Information
To remove the window for cleaning:
1. Remove the side doors and the plinth.
2. Find the levers on each
side of the window
towards the top. Using
your
fi
nger, pull the levers
towards you and unhook
them from the window
frame brackets.
3. Gently pull the top of the
window outward.
4. Lift the window out of its bottom railing and set it
aside in a safe place to avoid damage.
To re
fi
t the window:
1. Place it in its bottom railing and push its top against
the
fi
rebox.
2. While you hold it, pull the side levers back into the
window brackets on each side.
3. Apply light hand pressure against the window frame
sides to bed-in the window seal.
4.
If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
IMPORTANT:
To ensure a safe operation, verify
that the levers are hooked properly to the window
tabs; then, pull out the top of the window and
release it to insure the springs return it.
Remove plinth
Remove side doors
Hot Glass Warning Plate
OWNER’S
INFORMATION
Содержание 1500IN
Страница 58: ......
