49
Battery box
connection
Reset
button
The receiver and the handset of the remote control sys-
tem must be initially synchronized before the
fi
rst use.
1. Insert one 9 V alkaline battery in the handset.
2. Locate the Reset button on the top side of the
receiver.
3. With a sharp object, press and hold the receiver’s reset
button until you hear one short and one long beeps.
Release the reset button after the second beep.
4. Within the subsequent 20 seconds, press the (small
fl
ame button ( ) on the remote handset until you
hear two short beeps con
fi
rming the synchronization
is set.
This is a one time setting only and is not required
when changing the batteries in the remote receiver.
The remote control system is now ready to use.
Remote Control Initial Set-up
CAUTION
To avoid short-circuit to the receiver, position
the
antenna
so that it
DOES NOT TOUCH the
ignition wire.
Wall Switch Kit Installation
8. Disconnect the wire from the battery box.
9. Remove the cover of the battery box (1 screw).
10. Insert four AA alkaline batteries in the battery box,
re
fi
t the cover and secure with the screw.
11. Reconnect the battery box and place it back in its po-
sition to the right at the bottom of the appliance case.
12. Test the operation of the wall switch.
13. Fix the wall cover plate to the outlet box.
14. Replace the receiver in its position and as well as
the antenna if deployed.
IMPORTANT: The antenna MUST NOT TOUCH
the ignition wire.
QUALIFIED
INSTALLER
Содержание 1500IN
Страница 58: ......
