4
3. On the appliance, install the side panels as indicated
(3 x 1/2" screws per side).
4. Install the upper
fi
nishing strip in the orientation
shown below, under the appliance's case top edge.
The
fi
nishing strip is secured to the appliance using
the removable ba
ffl
e's 4 existing screws holes.
With no HeatShift.
Remove the 4 screws retaining
the removable convection ba
ffl
e and discard them.
Slide the
fi
nishing strip over the ba
ffl
e's tabs, then
secure the strip and ba
ffl
e together to the appliance
using 4 countersunk screws supplied with this kit.
Curves upwards
in fireplace
Bottom
Front
Rear
Side View
Convection baffle
Finishing strip installed
Finishing strip
ONLY
with HeatShift.
Remove the 4 screws retain-
ing the removable convection ba
ffl
e. Remove the
ba
ffl
e, then slide the
fi
nishing strip over the screw
holes and secure it to the appliance with 4 counter-
sunk screws supplied. Discard the convection ba
ffl
e
and its original screws.
Ensure there is no gap between the upper
fi
nishing
strip and the side panels.
If there is a gap, loosen the side panel's 3 screws,
push the panel up to close the gap and tighten the
screws.
NOTE
Use of the optional HeatShift System requires
the convection baffle to be removed above the
firebox. See Appliance Preparation, Optional
HeatShift or HeatShift section in Appendix D of
the appliance's installation manual.
Convection baffle
removed
Finishing strip installed
Finishing strip
Side
panel
Upper
finishing strip