8
Owner’s Information
CAUTION
DO NOT USE
a screwdriver or other metallic
object to remove the batteries from the receiver or
the handset! This could cause a short circuit to the
receiver.
glass cover retaining tabs.
3. While holding the glass cover so it does not fall and
shatter, swivel one or both of its retaining tabs to
free the glass. Gently remove the glass cover.
4. Remove the light bulb from its socket by pushing
towards one end.
5. With a gloved hand, replace with a new light bulb
using only a
100 watts halogen 130 volts (type J
T3, 119 mm long)
.
6. Test the bulb by turning the wall switch on. Turn
the switch off again to complete the operation.
NOTE: If the bulb is new and not functioning, turn
off the dimmer switch and call your local electrician
for inspection.
7. Put the glass cover back in place and, while
holding it, turn the retaining tab(s) to retain
the glass.
8. Tighten the tabs’ screws.
Using Handset Wall Holder
Your
fi
replace equipment includes a wall
holder to store the handset. If it hasn’t be
installed, refer to the instructions further
on in this manual for the installation.
Replacing Batteries
Low battery signal: see page 15.
BEFORE changing the batteries, turn off the valve
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the
fi
replace cool
fi
rst before touching it.
!
Light
fi
xture without glass cover
100W Halogen Light Bulb (119mm)
Light
fi
xture with glass cover
Tab
Tab
opening (b).
Checking Pilot and Burner Flames
A periodic check of the pilot and burner
fl
ames should
be made. Check after the
fi
re has been on for at least
30 minutes. The pilot
fl
ame must cover the tip of the
thermocouple probe. The main burner
fl
ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl
ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Replacing Light Bulb
The appliance is equipped with a decora-
tive light inside the
fi
rebox located in front
of the window. To replace the light bulb,
follow these steps:
1. Turn off the decorative light wall switch.
2. Locate the light
fi
xture. Loosen the screws of the
Correct Flame Picture
Pilot Flame can be seen between logs
Pilot Flame
Thermocouple
Probe must be in
Flame
OWNER’S
INFORMATION
