8
Owner’s Information
If the antenna was
unhooked when
replacing batteries,
hook it back to its
clip.
NOTE: It MUST
NOT TOUCH the
ignition wire!
Antenna
Ignition Wire
!
CAUTION
DO NOT USE
a screwdriver or other metallic
object to remove the batteries from the receiver or
the handset! This could cause a short circuit to the
receiver.
CAUTION
To avoid short-circuit to the receiver, position the
antenna
so that it
DOES NOT TOUCH the ignition
wire.
Batteries
Low battery signal: see page 14.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —
see instructions
next page.
The appliance uses four 1.5 V AA alkaline batteries
for its remote control receiver and one 9 V alkaline
battery for its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should
the batteries lose power, the control may be operated
by manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
:
1. Open the side panel to the left of the window.
2. The receiver is located under the valve and it is
retained to its platform by a
Velcro
tab. Grab the
receiver and pull it out from it’s platform.
3. Slide and remove the receiver cover.
4. Replace the 4 AA batteries.
5. Replace the cover.
6. Put the receiver back on its platform pushing it in
so it attaches to the
Velcro
tab. If it was unhooked,
replace the antenna in its clip.
IMPORTANT: The antenna MUST NOT TOUCH
the ignition wire to avoid a short-circuit.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the
fi
replace cool
fi
rst before touching it.
Lighting, Operation and Rating Information
The Lighting, Operation and
Rating information is located
on a plate at the right hand
side of the
fi
rebox behind the
side door.
To access the plate, open
the right hand side door and
grab the plate and slide it out
to read it. There is important
information on both sides of
the plate.
Servicing
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance serial number can also be
quoted. This number is on the rating plate, which is
located on the right hand side of the
fi
rebox behind
the side door. Open the side door and slide the plate
out. The replacement parts are shown at the end of
this manual. Please always quote the part number and
description when requesting spare parts.
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT!
Let the
fi
replace cool
fi
rst before touching it.
The data plate is
located on the right of
the
fi
rebox behind the
side door.
!
!
OWNER’S
INFORMATION
