7
Light
fi
xture without glass cover
100W Halogen Light Bulb (119mm)
Checks
A periodic check of the pilot and burner
fl
ames should
be made. Check after the
fi
re has been on for at least
30 minutes. The pilot
fl
ame must cover the tip of the
thermocouple probe. The main burner
fl
ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl
ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Remote Control Handset Wall Holder
Your
fi
replace equipment includes a wall
holder to store the handset. If it hasn’t
be installed, refer to the instructions
further on in this manual for the
installation.
Correct Flame Picture
Pilot Flame
can be seen
between logs
Owner’s Information
Pilot
Flame
Thermocouple
Probe must be
in Flame
Light
fi
xture with glass cover
Tab
Tab
Light Bulb Replacement
The appliance is equipped with a decora-
tive light inside the
fi
rebox located in front
of the window. To replace the light bulb,
follow these steps:
1. Turn off the decorative light wall switch.
2. Locate the light
fi
xture. Loosen the screws of
the glass cover retaining tabs.
3. While holding the glass cover so it does not fall
and shatter, swivel one or both of its retaining tabs
to free the glass. Gently remove the glass cover.
4. Remove the light bulb from its socket by pushing
towards one end.
5. With a gloved hand, replace with a new light bulb
using a 100 watts halogen 130 volts (type J T3,
119 mm long).
6. Test the bulb by turning the wall switch on. Turn
the switch off again to complete the operation.
NOTE: If the bulb is new and not functioning, turn
off the dimmer switch and call your local electrician
for inspection.
7. Put the glass cover back in place and, while
holding it, turn the retaining tab(s) to retain
the glass.
8. Tighten the tabs’ screws.
OWNER’S
INFORMATION
