Disconnecting the Battery
To prevent a short circuit, turn off the ignition and remove the negative (-) battery cable prior to
starting the installation.
NOTE:
If the unit is to be installed in a car equipped with an on-board drive or navigation
computer, do not disconnect the battery cable. If the cable is disconnected, the computer
memory may be lost. Under these conditions, use extra caution during installation to avoid
causing a short circuit.
NOTE:
It is especially important that you read the
WARNINGS
and
NOTES
in this manual.
Controls and Indicators
Button Operation
3
4
10
5
2
1
6
7
8
9
11
12
13
15
16
17
14
3
2
1.POWER OFF/VOL
Rotary encoder.
Press the encoder to turn on the unit, press and hold to turn off.
Rotate clockwise/counterclockwise to adjust the volume.
Press to enter the audio adjust menu when the unit is on.
Press to answer an incoming call (if the unit has been connected to a Bluetooth enabled cell
phone).
2.
IR REMOTE CONTROL RECEIVER
3.
SRC
Press to select a source.
Press and hold to toggle rear zone mode On/Off.
4.
MUTE
Press the button ( ) to mute the volume, and press the button again to restore the volume.
5.
PREVIOUS
6.
NEXT
7.
PLAY/PAUSE
Press to play/pause.
8.
BLUETOOTH MICROPHONE
9.
SD CARD SLOT
10.
DISC SLOT
11.
RESET
18
19
20
21
22
23
6. To prevent injury from shock or fire, never expose this unit to moisture or water.
7. Never use irregular discs, the only recommended disc size is a 12cm round disc.
8. To prevent damage to the mechanism inside this unit, avoid impact to the TFT monitor.
9. Do not change the fuse on the power wire without professional guidance. Using an improper
fuse may cause damage to the unit and result in a fire.
10. The monitor employs an automatic motorized mechanism. To prevent damage to the core
mechanism, please do not push, pull or swivel the monitor manually.
Содержание NVG-720W
Страница 1: ...NVG 720W ...
