Valor Fires Clarissa, Руководство по установке

Страница: 10 / 12

Step 7. Checking for gaps.

Before continuing with the
installation of the surround and back
panel it is important to ensure that
there are no gaps between the
surround and back panel or surround
and wall.To do this, place the back
panel and surround in place. If any
gaps exist then adjust the distance
between the wall strips and the wall.
To adjust the distance of the strips to
the wall, simply loosen the screws
securing the strips to the brackets,
adjust to the required depth and
tighten the screws.
Step 8. Securing the wall brackets.

Place the wall fixing brackets (K) 110mm from the top of the surround as shown
in figure 7. Secure in place using six (L) screws.
Step 9. Securing the
surround assembly.

There are two wall
fixing points shown in
figure 8. Mark the
positions of the fixing
points on the wall. Drill
suitable sized holes at the
fixing points for the wall
plugs supplied. Insert two
wall plugs (J). Insert two
screws (M) leaving
approximately 3mm
between the wall surface
and the rear of the screw
head. Lift the surround
and locate the keyhole
slots over both screw
heads. The screws can be
adjusted to obtain the best
fit. This will require
removal of the surround.
©
Baxi Heating U.K. Limited 2009.
INSTALLATION GUIDE
Page 10
Figure 8. Fixing point locations.
Figure 7 .
(K)