7.
Supplied with the fire are a short and long
length of self adhesive foam seal. Take the
short length, peal off the adhesive backing
and stick it to the underside of the hotbox
(See figure 11).
8.
Supplied with the fire is a spacer frame.
This is made up of three separate pieces, a
top and two sides. The three pieces are
identified in figure 12.
9.
The sides have a stepped top face. These
must be located on the inside the top piece
(See point 1 of figure 13). The tabs on the top
piece must locate on the inside of the side
pieces (See point 2 of figure 13). Secure the
two side pieces to the top piece using
two self tapping screws supplied.
Locate the screws from inside the ‘U’
channel.
Page 20
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 13. Spacer frame assembly
Figure 12. Assembling the spacer frame
Figure 11. Fitting the foam seal to
the base of the hotbox.
