©
Baxi Heating U.K. Limited 2009.
Page 26
8. FASCIA FITTING
Before continuing with the installation of this appliance it is important that the
information contained on the back pages of the Owner guide is completed.
8.1 To fit the closure plate baffle.
The closure plate baffle is supplied with the
fire and is intended for use where the height
of the closure plate and sealing tape is
greater than 580mm. When using the baffle
the height of the sealing tape and closure
plate can be extended to a maximum
630mm.
At the rear top corners of the fascia there
are two screws, one at each side.
Loosen the screws but do NOT remove
them.
Locate the baffle onto the screws as in
figure 14. The baffle is angled and should
lean towards the rear of the fire.
Tighten the screws to secure.
8.2 To fit the fascia.
Place the fascia over the engine. Make sure that the top rear of the fascia locates
fully into the ‘U’ shaped notch of the
engine back panel (See figure 15).
Fit the control knob firmly on to the
control spindle.
Secure the fascia using the two screws
previously removed. There are two holes
in the fascia. Use the bottom hole.
INSTALLER GUIDE
Figure 14. Closure plate baffle location
Figure 15. Fascia top location
Содержание 348 Brava
Страница 45: ...Baxi Heating U K Limited 2009 Page 45 OWNER GUIDE...
Страница 48: ...Baxi Heating U K Limited 2009...
