Page 37
5: Replace IBT belt cleaning component
When the IBT belt cleaning component is close to the end of its service lift, the printer's control panel will show the
following message.
Message
Measure
Ready for printing Replace IBT
The IBT belt cleaning component shall be replaced immediately. Please replace it
according to the following steps.
Please refer to the "reset counter" (page 44) to reset the counter.
Note: If it indicates that the component has reached the end of its service life but
can still be used, then you can reset the counter directly.
8-4-5
Hold the fuser unit with one hand and fasten the screws on both
sides with the other hand.
8-4-6
Press the middle part of the upper left cover A to close the cover
gently and then close the side door.
8-5-1
Please make sure the machine is not in running and then
open the front cover.
8-5-2
Turn the IBT belt cleaning component cover on the front
right side and open it.
8-5-3
Release the knob, then turn it to pull it out.
8-5-4
Pull and lower the IBT belt cleaning component with
both hands to remove it.
