background image

2

MANU

AL

VENTILATION CONTROL

In buildings with a centralized ventilation that allows the 

residents to boost extraction during cooking, this is done using 

the adjustment damper of the hood. 
The cooker hood meets the requirements set for a fire damper 

and for sound-dampening between apartments.

USING THE COOKER HOOD

The cooker hood has a sliding glass that can be pulled out of the 

cooker hood. It is recommended that the sliding glass be pushed 

or pulled from the aluminum strip on its front edge. Pull the glass 

out of the cooker hood for maximal extraction capacity.

  Position of the damper 

In normal circumstances, the damper must be closed (the 

signal light is off), which boosts the extract air flow from other 

premises.
The damper must be open (the signal light is turned on) when 

the user wants to increase the extract air flow from the cooker 

hood e.g.

•  when the cooker top or the oven is used for cooking or
•  the load in the kitchen is exceptional due to the use of 

strong detergents, presence of a large number of people, 

or similar.

Touch the button on the damper to open it and to start the timer. 

The damper will close automatically within 60 minutes. When 

the damper is closed, air extraction from other premises is 

increased. 

Front panel buttons

The front panel of the cooker hood has two buttons.

  Cooker hood light

Turn the light on or off by pressing the light switch. The light is 

dimmable. Adjust the brightness by pressing the light switch until 

the brightness is adequate.

MAINTENANCE

Keep the cooker hood clean. Wipe outer surfaces regularly with 

water containing a small amount of a mild detergent. Clean off 

any grease stains immediately. Do not use abrasive or corrosive 

detergents or tools. 
Keep the grease filter clean to ensure an adequate extract air 

flow. The grease filter must be washed with warm water and 

detergent at least 1-2 times a month.

Light

The cooker hood has a long-lasting LED lighting module. If the 

light is not working, contact a servicing company.

Removing and mounting the grease filter

Removing the filter

Mounting the filter

•  Pull the locking device of the grease filter towards the front 

edge of the cooker hood while pulling the grease filter 

downwards until it comes off. 

•  Wash the grease filter and leave to dry.
•  Mount the grease filter back in place. Push the front edge of 

the filter into the pins on the cooker hood, and click the rear 

edge in place.  

NOTE! Ensure that the locking device points downwards.

  

PLEASE NOTE!

•  Neglecting the cleaning of the grease filter can cause 

a fire hazard.

•  The outer surfaces of the hood can become hot when 

the cooker or the oven is turned on.

•  Flaming is forbidden underneath the cooker hood.
•  Always follow the instructions provided on adjusting 

the efficiency of ventilation.

•  Enable a sufficient supply airflow into the room if 

the cooker hood and non-electric devices are used 

simultaneously.

Other functions

Guard function

The cooker hood is equipped with a guard function that is 

activated when the temperature of the cooker hood exceeds 

60°C or after a sudden increase in temperature (> 8°C/min). In 

such a case, all signal lights of the cooker hood and the LED light 

will flash. If this kind of alarm is noticed before fire damage, it can 

be acknowledged by pressing any of the cooker hood buttons.

Pre-selection of light brightness

The hood has a button for adjusting the brightness of the light. 

The location of the button is not marked on the front panel but 

can be found roughly 2 cm to the left of the light switch.

To modify the pre-selection of light brightness:

1.  Turn on the light, close the damper, and set the ventilation 

to the Away profile.

2.  Press the selection button for roughly 3 seconds until the 

setting mode signal light starts to flash.

3.  Adjust the brightness of the light by pressing the light 

button until the brightness is adequate.

4.  To save the setting, press the selection button for roughly 3 

seconds until the setting mode signal light stops to flash.

To read about the other functions of the selection button, go to 

our website, www.vallox.com.

  

WARNING!

The unit is not intended for use by children under 8 or 

by persons with reduced sensory, physical or mental 

capabilities, or whose lack of knowledge and experience do 

not ensure safe operation of the unit.  Such persons can use 

the unit under supervision, or by following the instructions 

of someone who is responsible for their safety.  Do not let 

children play with the unit or to clean or maintain it without 

supervision.

Отзывы: