Valiani OMNIA, Инструкция по эксплуатации и техническому обслуживанию

Страница: 48 / 66

OMNIA
44
•
Insert the blade holder (1) into the cutting head and tighten
the set screw (2).
•
Reassemble the head (see chapter 6.7.12).
6.7.9 REPALCYING THE FOOT/ROLLER ON WHITE HEAD - VERSA TOOL (OPTIONAL)
Warning! Handle the blade carefully, protect it, if necessary, to avoid cutting. During reassembly use a
rubber object to keep it in its housing during tightening of the locking screw .
To replace the roller with the presser foot, and vice versa, proceed as follows:
•
Disassemble the head (see chapter 6.7.13).
•
Remove the blade holder ( see chapter 6.7.8).
•
Unscrew the screw (6) to remove the roller and the support (7).
•
Screw the foot (8) with the screw (6).
Follow the same procedure to replace the foot with the roller.
•
Reposition the blade holder ( see chapter 6.7.8).
•
Reassemble the head (see chapter 6.7.12).
1
2
7
6
6
8
Figure 6-22
Figure 6-23