Valiani OMNIA, Инструкция по эксплуатации и техническому обслуживанию

Страница: 41 / 66

OMNIA
37
6.7.1 POSITIONING THE MATERIAL ON THE LOADER TABLE
Two loading/processing modes are available; the first foresee to have all materials stacked on top of each other, the
second to have the same material/job loaded on two stacks side by side.
The second mode allows processing two sheets at the time, reducing loading times by half.
Note. The dual Sheet mode is only available for sheets with a maximum width of 340 mm (13.38") and a
minimum width of 200mm (7.87").
6.7.1.1 STANDARD POSITIONING THE MATERIAL ON THE LOADER TABLE
To load the materials, place the loader selector in manual mode (MAN), (Figure 6-4) then keep the Up / Down selector
in the Down position to lower the loading surface.
Position the materials to be processed on the loading surface so that they are pushed against the stop on the front
and against the stop on the left side for the 0 position.
Then place the movable stops on the sides of the materials to keep them in the correct position.
Be careful not to position the supports beyond the line drawn on the surface (A), as they would interfere with the
reading of the photocells.
NOTE! To ensure the correct function of the loading phase, we recommend always using materials of the
same type and size within a work cycle.
After placing the materials and supports on the loading surface, return the selector to AUTO mode.
0 (zero) Point
A
Figure 6-8
Figure 6-9