- 11 -
g
!
!
IMPORTANT! The circular saw is suitable
for cutting wooden panels. It is prohibited to
cut dangerous materials, metals, plastics or
to use the tool in environments with risk of
fire/explosion.
The circular saw is made for DIY and not pro-
fessional use.
These instructions contain information deemed
necessary for proper use, knowledge and
standard tool maintenance. They do not include
information on wood processing techniques; the
user can find additional information in specific
books or publications or by attending special
training courses.
SYMBOLS
Carefully observe the symbols in fig.B and
memorise their respective meanings. Correct
interpretation of the symbols allows a safer use
of the machine.
1 Technical data
2 Double electric insulation
3 Electric and electronic waste may contain
potentially hazardous substances for the
environment and human health. It should
therefore not be disposed of with dome-
stic waste, but by means of differentiated
collection at specific centres or returned to
the vendor in the event of purchasing a new
identical power tool. The illegal disposal of
waste will result in administrative sanctions
4 Certifications
5 Lot number
V Volt
Hz Hertz
~
alternating current
W Watt
kg kilograms
mm millimetres
s seconds
n
0
no-load speed
min
-1
round per minute
dB decibel
double electric insulation
COMPONENTS
Refer to fig. A and the following figures, attached
to these instructions.
1 Motor body
2 Front cutting inclination adjustment han-
dwheel
3 Guide panel
4 Front hand grip
5 Rear hand grip
6 Start/stop switch
7 Safety button
8 Power supply plug and cable
9 Rear cutting inclination adjustment handwheel
10 Mobile guard for blade
11 Graduated guide set square
12 Guide set square fixing handwheel
13 Fixed guard for blade
14 Blade fixing screw and washer
15 Blade fixing flange
16 Blade
17 Cutting height adjustment handwheel
18 Chip opening
19 Adaptor for vacuum hose
20 Key for blade screw
21 Blade lock button
22 Marking for cutting area
23 Handle for guard retraction
INSTALLATION
!
!
IMPORTANT! The manufacturer is not
liable for any direct and/or indirect damage
caused by incorrect connections.
!
!
IMPORTANT! Before carrying out the fol-
lowing operations, make sure that the plug is
disconnected from the mains.
Take out the machine tool and components and
visually check that they are perfectly intact.
TRANSPORT
Always use the packaging or case when tran-
sporting the tool; this will protect it from impact,
dust and humidity which can compromise
normal operation.
MOVING
Grip the tool by the hand grip and after use wait
for it to stop completely before putting it down.
STARTING UP
When choosing where to use the electrical tool,
the following should be considered:
