- 8 -
g
!
!
IMPORTANT! Before using this electrical
tool, carefully read and observe the safety
standards and operational instructions provi-
ded hereafter. Make sure that you know how
to stop the tool in case of emergency before
starting the job. Incorrect use of the heat gun
can cause severe burns or fires.
!
!
IMPORTANT! During use, the nozzle of the
gun reaches high temperatures. Do not touch
these parts. Only put the tool back once it has
cooled down completely. Do not leave the tool
to cool on flammable surfaces or near flam-
mable or explosive substances.
Carefully keep this instruction handbook in a
safe and handy place so that you can consult
it when needed.
!
!
IMPORTANT! The heat gun is suitable for
stripping surfaces covered in oil paint, paint
and wallpaper. The tool can also be used to
defrost metal pipes, to dry wet paint, to mould
or shrink plastic and to melt glue or wax. Any
other use than those specified herein can cau-
se damage to the tool and constitute serious
danger to the user. It must not be used on
people, animals, pressurised containers, elec-
tric cables or flammable/explosive materials.
!
!
IMPORTANT! FOR D.I.Y. USE ONLY
DESCRIPTION OF HEAT GUN (FIG. A)
1 Handle
2 Switch
3 Nozzle
4 Air ventilation slots
5 Power supply plug and cable
6 Support position
7 Support stand
DESCRIPTION OF MARKS AND SYMBOLS
(FIG. B)
1 Technical data.
2 IMPORTANT!
3 Read the instruction manual carefully.
4 IMPORTANT! Hot surfaces, risk of burns.
5 Wear protective gloves.
6 Wear protective goggles.
7 Electric and electronic waste may contain
substances that are dangerous for the
environment and for human health. For this
reason they must never be disposed of
together with domestic waste, but collected
separately in specific collection centres or
returned to the retailer when similar new
equipment has been purchased. The illegal
disposal of such equipment may result in
prosecution to the full extent of the law.
8 Double insulation.
9 Conformity marking.
10 Lot number.
TECHNICAL DATA
Voltage and nominal frequency 230V~50Hz
Min. absorbed rated power 1000 W (350
0
C)
Max. absorbed rated power 2000 W (600
0
C)
Machine insulation class
II
GENERAL SAFETY REGULATIONS
1) It is prohibited for children and unskilled
personnel to use the machine.
2) Always check the efficiency and integrity of
the tool. It can cause serious injury to the
person using it.
3) Keep a safe distance from property, people
and animals and do not allow them to ap-
proach while you are working.
4) Do not use the tool in closed or poorly ven-
tilated areas or in the presence of flammable
and/or explosive liquids, powders, gases or
anything else of this kind.
5) Always use a suitable temperature for the job
you need to do, hence preventing the risk of
fire.
6) Never remove any tool components and do
not modify it in any way.
7) The operator is responsible for third parties
in the tool work zone.
8) Tie back long hair and clothing as they could
get stuck or burnt in contact with the tool.
9) During work, always wear suitable safety
goggles and gloves.
10) Never direct the flow of air towards people
or animals.
11) Do not use the tool as a hairdryer.
12) Do not touch the metal nozzle during or after
operation.
13) If you concentrate the jet of hot air in one
