Проверил: Р.Ч./24.03.2015г
8
STEP 1
Using a 5 mm hex wrench
⑩
(provided) to loose the blade screw 11 which secures the blades. Remove
the blade screw and bush together.
Remove the moving blade
②
as shown
.
Be careful not to allow any foreign matter to become attached to the blade gear and do not damage
it.
(Must make the moving blade to occupy opens or partly opens the condition.)
STEP 2
Insert the moving blade
②
to fit the screw hole as shown.
Refit the blade screw 11 and the bush together. Ensure the bush
is located through fixed blade and
moving blade.
Tighten the blade screw 11 by using a 5 mm hex wrench
⑩
(provided). Do not overtighten.
3
，
After Pruning/Storage
�
Warning! Always push the safety switch
③
to “OFF” position.
�
Always wear protective gloves when using, adjusting or cleaning the machine.
Clean the exterior of the machine thoroughly using a soft brush and cloth. Do not use water, solvents or
