BUS BODY ELECTRONICS
7
2.2.2 Deactivation
Press
button if Auto mode is on
➔
Mode is off - corresponding status light and function
symbol are off (Figure 9).
2.3 Configuring the blowers manually
2.3.1 Activating the controller manually
Press
button
➔
Manual operation of the blower is activated - the
blower will continue running at the current speed.
➔
The blower level can be manually set 3 seconds after
pressing the blower level button (the corresponding
status light
blinks
during this time).
2.3.2 Setting blower level
The blower can be set in level increments of 0 (blower speed = 0%) to 10 (blower speed =
100%).
Press
button
➔
Blower level +1 (
→
).
Press
button
➔
Blower level -1 (
→
).
Note
When Auto mode is deactivated, the air conditioning com-
pressor (after a run time of 90 seconds max.) and the heater
are turned off.
The blowers will continue to be controlled automatically if the
blower level was not manually configured.
Note
Configurations can only be applied within the permitted limits
(e.g. vehicle motor off
→
blow speed max. 25%).
If the blower is set below 20%, the cooling and heating func-
tions are deactivated.
Figure 9 - SC600 Auto mode
deactivated
Figure 10 - SC600 setting the blower
level manually
