24V BACA
OPERATION MANUAL
7
AUS
1300 734 253 NZ 0800 734 253
Reading the Test Results
In the main menu go to the read test result display and press the START/STOP button.
Pressing the DISPLAY CHANGE button, you can see the result of each cycle. A cycle consists of a charging and a discharging
part.
The last cycle is always a half cycle. It means that there is only charging because the tester charges the battery after the test
process. So, if you have programmed 4 cycles, after the 4th cycle the tester connects the charger to the battery and does
the charging. When reading the test result of the last cycle, you see only charged Ah.
025min
06.2A*h
4/5 Read
05.2A*h
Minutes
Discharged Ah
Cycle #
Charged Ah
To go back to the main menu, press the START/STOP button.
STARTING THE TEST
Start with Discharging
If the battery is fully charged, you can start the test with discharging. In this case, the first cycle is a half cycle (there is no
charged Ah), you will see only discharged Ah when reading the test result.
To start the test with discharging, change to the discharge screen (see menu system) and press the START button for 1
second.
Start with Charging
If it is necessary to charge the battery before discharging it, you should select this type of start. In this case, the tester
connects the charger to the battery and does the charging if you have programmed the charging time. ou can program the
charging time in the Test Parameters menu.
To start the test with charging, change to the Charge screen (see menu system) and press the START button for 1 second.
Before the tester starts the process, it checks if there is a charge connected to it. If not, it will ask you
Charger Ready??
.
During the Test
During the test, you can see the following screen:
0025min
1.3Ah
1/1 Disch
12.0V
Elapsed time
Voltage
Cycle Process
Ah
