2
947628
CAUTION: To reduce the risk of electric shock,
Do not remove cover.
No user serviceable parts inside.
Refer servicing to qualified service personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
instruction manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area may cause
harmful interference in which case the user will
be required to correct the interference at his own
expense.
Precautionary Designations
Mounting (VIP-LLE)
The VIP-LLE Network Extender is designed for wall
or shelf mounting and must be within 300 feet of the
network switch.
Shelf:
Provided with the VIP-LLE Network Extender
are four rubber pads. Peel the pads from the carrier
backing and place at the four corners of the bottom of
the unit.
Wall:
Using the brackets and wood screws provided,
secure the VIP-LLE Network Extender
to the wall.
Mounting (HORN)
The horn should be mounted 15 to 20 feet above the
floor to allow for best sound distribution. The unit can
be mounted to a wall, a beam or an electrical box.
NOTE:
For ease of installation, the base can be
attached to the speaker before or after the base is
mounted.
Loosen position adjustment knob
Insert the ball of the base into the socket of
the speaker
Tighten the position adjustment knob
Mount the base to a wall using the two
pre-drilled holes provided.
A “C” clamp is provided with the horn to allow
mounting to a beam. Place the bolt through
the hole in the bottom of the base to secure
the “C” clamp to the beam. It is suggested
that the horn be mounted to the underside of
the “I” beam to provide maximum positioning
adjustments.
The base has pre-drilled holes for a double-
gang square electrical box, but by drilling out
additional knockout holes, the base can be
mounted to a single-gang or octagon box.
The horn may be rotated or moved up and down to
obtain the desired position by loosening the position
adjustment knob at the bottom of the unit
approximately one turn. Make required adjustments
and re-tighten knob.
