www.valcom.com
I
540.563.2000
I
800.825.2661
®
VIP-102B
IP Solutions SetupTool
Page 9
The following items are configurable. Some options require additional licenses.
Paging Mode
– Select between Analog and Valcom. Valcom Paging Mode is only selectable if the Gateway option (L9972-2)
is licensed.
•
Analog
– Basic input from FXS, FXO, or SIP to the Analog One-Way Page output or Talkback output. Paging is output
only from this device to the selected analog output.
•
Valcom
– Acts as a gateway between FXS, FXO or SIP to Valcom IP devices for paging or intercom. Calls may be
inbound or outbound from this device
Absolute Timeout
– The maximum number of seconds before the device will hang up the page. This is only configurable in
software if DIP switch SW4 and SW5 are ON. The allowable range is 0-3600 seconds. Set to 0 to disable this timeout.
Silence Timeout
– The number of seconds during which no audio is present on the input before the device will hang up
the page. This is only configurable in software if DIP switch SW2 and SW3 are ON. Allowable range is 0-600 seconds. Set to 0
to disable this timeout.
Phone Admin Passcode
– The digits that must be keyed into the phone to gain access to DTMF programming. This can be
from 0-10 digits.
Page Security Code
– The digits that must be keyed into the phone to make a page. This can be 0-10 digits (leave blank
to disable).
Page Volume
– Selectable volume output of Low (-10dBm) or High (2.2dBm) for analog One Way Page Out signal.
Pre-Announce Tone
– Check to play alert tone over speakers at the start of a page. Uncheck to disable.
Use Custom Pre-Announce Tone
– If checked, allows loading a custom page tone. An Upload Device Files dialog box will
display when selecting the Upload File button. (See Upload Device Files under the Communications menu option.)
Paging Method
– Live or Store and Play. If Live is chosen, no further options are available and paging audio will pass
through the V-9972 as it is spoken. If Store and Play is chosen, the paging audio will be recorded by the V-9972 and played
out when the call is disconnected. Other configuration options become available with Store and Play.
•
Page Replay Control
– This is the number of times (0 to 5) to repeat the page when using Store and Play.
•
Inter-Page Timing
– The number of seconds (1 to 10) between repeats when using Store and Play.
•
FXS / FXO Channel Priority
– The priority of the page that comes from either the FXS or FXO input.
Selectable options are Low, Medium, and High. Page Group priority 20, 35, and 50 respectively.
(SIP tab Channel Priority determines IP priority with same options)
•
Collect DTMF
– This is only available when using the Talkback Page Out (DIP switch SW1 is ON). Typically, this
is used when connecting to a multi-zone controller which requires DTMF digits to select a paging zone.
— Dial Code Length – Sets the number of digits to collect. The digits keyed in will be output before the
recorded audio page is played.
— Delay After DTMF – The number of seconds to wait between the output of the last recorded DTMF digit and
the beginning of the recorded audio.
