2
947170
INSTALLATION
Input Access / Switch Settings
A four position slide switch is used to select the
telephone access mode.
•
(LS) Loop Start
Used with a Loop Start Trunk Port of a PBX or
Key System, or a dedicated phone set.
•
(GS/LSS)
Ground Start/Loop Start Supervised
Access from a PBX Ground Start Trunk Port.
In this mode, the PBX ground
must
be con-
nected to pin 1 of the 20-pin connector on the
PagePal
®
or pin 2 of the RJ11 connector on
the PagePal.
In Loop
Start
Supervised
mode, pin 7 of the
PagePal
must
be connected to pin 1 on the
20-pin connector to allow supervision of the
Loop Start Trunk Port. The PagePal will super-
vise the connection, and will automatically dis-
connect the line if no voice is detected on the
line for 20 seconds or if the line remains active
(off hook) for more than one minute.
•
(SA) Station Access
Used with a standard (ANALOG) station port
on a CENTREX, PBX, Key System, or Central
Office subscriber line. Use a two-wire RJ11
cable in this mode. The PagePal receives talk
battery and ring voltage from the host system.
•
(DL) Dry Loop
Interfaces with the Page Port of a PBX or Key
System, or an Auxiliary port of a PBX. This
input shall respond to resistances from 0 to 1K
Ohms and will ignore resistance greater than
10K Ohms. Use a four-wire RJ11 cable in this
mode. Dry Loop is a four wire connection.
Pins 2 and 5 of the RJ11 are intended to inter-
face with the control leads of the host system,
while pins 3 and 4 connect to Tip and Ring, as
usual. See Table 2 for pinout descriptions.
Main Output
Adjusts level of output. Full clockwise rotation
provides 14 dBm gain.
Set the Main Output level first using telephone
input, then adjust Attendant and Music Inputs for
an appropriate relative level.
Attendant Input
Adjusts level of Attendant Input relative to the
Telephone Input. Adjustment range is from 0 dBm
to less than -30 dBm.
Music Input
Adjusts level of Music Input relative to the Tele-
phone Input. Adjustment range is from 0 dBm to
less than -30 dBm.
TECHNICAL ASSISTANCE
When calling, have a VOM and a telephone test
set available and call from the job site. Call (540)
427-3900 and ask for PagePac Technical Sup-
port, or call (540) 427-6000 for Valcom 24-hour
Automated Support or visit our websites at http://
www.pagepac.com and www.valcom.com.
Should repairs be necessary, attach a tag to the
unit clearly stating company name, address,
phone number, contact person, and the nature of
the problem. Send the unit to:
PagePac
®
Repair Dept.
Valcom, Inc.
5614 Hollins Road
Roanoke, VA 24019-5056
Technical Manuals Online! - http://www.tech-man.com
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com
