VALCO MELTON D10, Руководство пользователя

Страница: 65 / 313

MM113 - D10/D16 Hot Melt Unit Section 5 - Setup
65
Shift Times/Setback Times
Programming Shifts
Three shifts can be programmed into the unit. Start shift, end shift, and setback times can be pre-programmed for
each shift to reduce downtime. Make certain all desired temperatures are set first (see Programming Temperatures,
this section).
First program the time the heaters will be on, off, and in setback for each of the three shifts. Use the Right/Left Arrow
Buttons to move through the times and shifts and the OK Button to get a thumbwheel to set the times and turn on the
setback feature with a “switch” on the thumbwheel. (The heaters can be set with or without using the setback times.)
Set the start, stop, and setback times for all shifts. Leave the unused shifts/times blank (— —).
This screen states that for Shift A, heaters will turn on at 7:00 AM to the setpoint temperatures (set on the
Temperature Screens, previously shown) and off at 3:00 PM, with all heaters going to the setback temperatures from
11:30 AM to 12:00 PM.
This screen states that for Shift C, nothing will be on, since there is no Shift C working.
After setting all shift times, program the shifts that will be enabled for each day of the week. The Up/Down Arrow
Buttons cycle through the different combinations of shifts, and the Left/Right Arrow Buttons cycle through the days of
the week.
From this screen, use the Up/Down Buttons
and the Right/Left Buttons to go through
and adjust the shifts and setback times as
desired. See the next page for an in-depth
review.