PAGE 5
INSTRUCTIONS
Remove the stroller from the carton. The
front wheels, rear wheels, child’s tray,
footrest and front canopy all need to be
installed prior to use.
A>UNFOLD YOUR STROLLER:
1. Lean the stroller so that the handlle and
rear frame tubes are resting on the floor
and the front wheel tubes are pointing
upward.
B>ATTACHING THE FRONT WHEELS
2. Position the front wheel assemblies so
that the large hole will slide over the front
leg tubes.
3. Push down on each assembly so that it
locks into place on each front tube.
IMPORTANT WARNING: PULL FIRMLY
ON EACH WHEEL AND TEST THAT IT
IS LOCKED SECURELY IN PLACE.
C>ATTACHING THE REAR WHEELS
4. Lean you stroller forward to rest on the
front wheels.
5. Install the rear wheel assembly,
positioning it so that the brake levers are
facing away from the stroller.
6. Place the wheel housings over the
wheel tubes. Press each of the spring
loaded buttons in turn and simultaneously
push the corresponding housing up over
the tube until it locks into place.
IMPORTANT WARNING: PULL FIRMLY
ON THE REAR ASSEMBLY AND TEST
THAT IT IS LOCKED SECURELY IN PLACE.
D>ATTACHING THE FOOTREST
7. Snap the footrest onto each of the front
legs just below the seat.
8. Push downward on the footrest until it
snaps onto the “U” shaped frame cross
member.
E>INSTALLING THE FRONT TRAY
9. Line up and insert the side channels in
the tray with the front leg tubes and insert.
10. Swing the latch on either side around
the tube and lock into place.
11. To remove the tray simply reverse this
procedure.
IMPORTANT WARNINGS:
THE FRONT CHILD TRAY IS NOT A
RESTRAINT DEVICE. ALWAYS SECURE
YOUR CHILD WITH THE HARNESS
RESTRAINT SYSTEMS PROVIDED.
DO NOT LIFT THE STROLLER BY THE
FRONT CHILD TRAY. ALWAYS USE CARE
WHEN ATTACHING THE FRONT TRAY
WITH A CHILD IN THE STROLLER.
F>INSTALLING THE FRONT HOOD:
12. Line up the square male fittings of
the canopy with the female fittings in the
armrest housing.
13. Push each fitting downward until each
snaps into place.
G>FOLDING YOUR STROLLER:
Close
the canopies:
14. Pull the rear canopy back up aginst the
handle.
15. Fold the front canopy backward until it
is flat to the stroller body.
16. Press the release button in the
centre of the handle while simultaneously
squeezing the fold button in the centre
of the handle. While holding these two
buttons, depress the foot pedal found
on the left side of the stroller.The stroller
should then begin to fold.
17. Release the handle and pull up on the
front tray until the stroller is fully folded.
18. Secure the stroller in the folded position
by swinging the fold latch, located on the
right side of the stroller handle, over the
extended rivet head on the armrest.
H>SEAT ADJUSTMENT:
19. The front seat can be reclined to 2
positions. Lift the trigger bar in the rear
of the front seat and move the seat to the
required position.
20. The rear seat can be reclined to a
multitude of positions. This is controlled
by the strap and buckle assembly located
behind the rear seat. To recline, loosen the
strap through the buckle and adjust to the
required position. The seat will then drop
to the appropriate position.
21. To lift the seat to a more upright
VEEBEE DoubleTakeIM_020818.indd 5
2/8/18 3:27 pm
