Your seat can be adjusted to 4 positions
using the zip system
1. To recline, pull one of the zippers
located on the seat side downward.
2. Do the same to the corresponding zipper
on the other side of the seat
3. For more recline, release more zippered
sections.
4. For seat incline simply reverse this
procedure.
BE SURE THAT ALL ZIPPERS ARE
OPENED/CLOSED FULLY BEFORE USE.
Adjusting your seat – zip/belt System
(selected units)
Installing your hood
Using your brakes
1. Place the plastic hood housings over
the corresponding housing on either
side of the stroller frame.
2. Align the straight track on the stroller
housing with the corresponding “hole”
in the hood housing.
3. Slide the hood housing downward,
over the track, so that it completely
engages onto the stroller frame.
“no zip” recline
(selected units)
The new “no zip” recline offers an
almost infinite amount of seat
adjustments:
1.
RECLINE
: While squeezing the centre
release mechanism in a pincer action,
ease the seat down to the desired
position.
2.
INCLINE
: Place your hand in the
centre of the rear of the seat.
3. Pull the incline strap while gently
pushing on the rear of the seat until
the desired position has been
reached.
IMPORTANT:
Always check
that the brake has fully
engaged
ALWAYS TEST
that the seat is securely
locked in place.
3. Press down on the side locking
hinges (on the basket) to lock the
frame in the open position.
4. Secure the handle to the frame by
engaging the locking clamps on
both sides.
In addition to the 4 adjustment
positions using the zip system, your
stroller has an additional 5
th
position
which raises the seat to an even more
upright sitting position.
1. With all zippers fully closed, lift
the seat back further upward with
your hand.
2. Secure the seat with the two sets
of straps (one at the top and one
at the bottom of the seat back),
inserting each buckle into the
corresponding buckle housing in
the matching strap.
NOTE
: Before using your stroller, be sure to attach the tether straps around the stroller frame by feeding the strap through
the slit in the steel buckle. While not essential for safety, these help reduce the motion of the seat within the stroller frame.
NOTE: Special care must be taken when
adjusting the seat position with a child in
the stroller. Before adjusting the zippers,
place your hand beneath the seat at its
current position and lift it slightly. This will
relieve pressure on the zippers and make
them easier to adjust.
There are two available brake systems
available for the Runabout Tri Mode
series:
STANDARD BRAKE (pictured)
1. Press down on the centre of the
brake bar until the bar ends engage
in the nylon brake cogs on the
wheel.
2. To disengage, lift the brake bar
upward till it locks in the upright
position.
CONCEALED BRAKE:
1. Press the centre toggle down firmly
with your foot until you feel the
wheels have locked.
2. To release, lift the centre toggle
from beneath with your foot.
IMPORTANT WARNING:
Always test that all axles, wheels, front bar, hinges and locks are securely engaged before use.
