WARNING
• FOLLOW THE MANUFACTURER’S INSTRUCTIONS.
• PUT ON ALL THE BRAKES WHENEVER YOU PARK THE PRAM/STROLLER.
• DO NOT LEAVE CHILDREN UNATTENDED.
• DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS PRAM/STROLLER.
• MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU ADJUST THE PRAM/STROLLER. OTHERWISE THEY MAY
BE INJURED.
Remember, your child’s safety is your responsibility...
•
NEVER USE ON STAIRS OR ESCALATORS.
• AlwAys use the tether strAp when the stroller is in use.
• the CorreCt use AnD MAintenAnCe oF this VehiCle Are essentiAl.
• Be sure thAt All ClAMps AnD BuCkles Are seCurely FixeD AnD in plACe BeFore use
• when in the stroller, your ChilD Must AlwAys weAr the sAFety hArness, CorreCtly FitteD AnD ADjusteD, At All tiMes.
• the MAxiMuM weight oF the oF the toDDler in this seAt is 20 kg’s.
• the optiMuM MAnoeuVrABility oF your stroller, pArtiCulArly when useD with the joey seAt, is only AChieVeD when
the tyres Are Fully puMpeD to the optiMAl operAting pressure. (40 p.s.i.)
• neVer reMoVe your hAnDs FroM the stroller hAnDle while your ChilD is in the joey seAt.
• CheCk All pArts BeFore use For BreAkAge or FAtigue. DisContinue use iMMeDiAtely iF Any pArt is FounD to Be
DAMAGED OR BROKEN.
• AlwAys plACe your ChilD into the joey seAt. neVer Allow your ChilD to CliMB into or out oF the seAt.
neVer leAVe the stroller At rest (pArkeD) with A toDDler in the joey seAt.
• neVer use this seAt iF the ChilD is unwilling to sit in it.
• AlwAys Be AwAre oF your ChilD’s position when sitting in the joey seAt. exCessiVe leAning to one siDe or while the
stroller is Cornering, MAy CAuse the unit to BeCoMe unstABle.
• extrA CAre Must Be tAken when using on uneVen surFACes.
• not reCoMMenDeD For A ChilD unDer 6 Months olD AnD/or unABle to sit up unAssisteD.
• Do not use this seAt with Any other MoDels oF prAM/stroller. only use this joey seAt with the CorreCt MoDel VAlCo
BABY STROLLER
• AlwAys ensure thAt eACh ChilD is CleAr oF All MoVing pArts when ADjusting the stroller.
• when in the stroller eACh ChilD Must AlwAys weAr the sAFety hArness, CorreCtly FitteD AnD ADjusteD, At All tiMes.
• AlwAys Be AwAre oF the risks proViDeD By Fire AnD other signiFiCAnt sourCes oF heAt suCh As rADiAtors, etC. whiCh
MAY BE IN THE IMMEDIATE VICINITY OF YOUR STROLLER.
• it MAy Be unsAFe to use Any ACCessories other thAn VAlCo BABy ApproVeD ones.
• this proDuCt is intenDeD For DoMestiC use only. it is not intenDeD For CoMMerCiAl use.
Should the chassis become wet, dry off promptly before storing. If this pram is used near the ocean or salted roads, spray the chassis and seat
frame with water and dry. We recommend a rust inhibiting product should be used to prevent rust and fatigue on metal parts.
We recommend that you wipe down axles and lubricate the wheels every 3 months. Sand and dirt can grind down axles, if you live near the beach
or in a dusty environment you must wipe down the axles and wheels then lubricate them monthly.
AXLES ARE BEST LUBRICATED WITH GREASE OR PETROLEUM JELLY. MOVING PARTS ARE BEST LUBRICATED WITH SILICONE BASED PRODUCTS.
DO NOT USE OIL BASED PRODUCTS.
FURTHER INFORMATION
In Australia/New Zealand
www.valco.com.au
In North America only
www.valcobaby.com
1800 610 7850
J
USING YOUR HARNESS
FIGURE G
Your VALCO BABY pram is fitted with a 5 point safety harness system.
Your child MUST always be harnessed while in the stroller.
TO SECURE YOUR CHILD IN THE HARNESS:
13. Insert Buckles (A) and (B) into either side of the Buckle Housing (C).
Keep inserting until they click into place securely.
14. Carefully adjust the harness straps to snugly fit your child by adjusting
the Sliders (D) located on all Shoulder Straps, Waist Straps and Crotch
Strap. The harness should be snugly fitted to the baby’s body, tight
enough so that the baby cannot wriggle itself free of the straps but
loose enough so as not to cause the baby any discomfort.
TO OPEN THE HARNESS:
15. Release the Buckle Prongs – Squeeze on the top and bottom prongs
simultaneously and pull apart from the Buckle Housing. This process
may be difficult as your buckle system has been designed to meet very
stringent safety standards to ensure that a child cannot release the
harness unaided.
