VALBERG UF 242 F W742C, Инструкция по эксплуатации

Страница: 8 / 27

12 13 FR FR
Nettoyage et entretien Nettoyage et entretien
C C
12 13 EN EN
Cleaning and maintenance Cleaning and maintenance
C C
Defrosting the freezer
• The freezer compartment will gradually get covered with ice. The ice must be removed.
• Never use pointed metallic tools to scratch the ice off the evaporator as you could damage
it.
• However, if the ice becomes very thick on the interior element, the appliance should be
completely defrosted following the instructions below:
− disconnect the plug from the socket;
− remove all the food, wrap it in several layers of newspaper and store in a cool place;
− hold the door open and place a container underneath the appliance to collect the defrosting
water;
− dry the interior thoroughly when defrosting is complete;
− insert the plug in the power supply to restart the appliance
WARNING !
• Disconnect the power supply before carrying out any repair
work.
• This appliance must be repaired by an approved after
sales service. Only original spare parts may be used.
• Important ! Certain noises can be heard during normal use (compressor, cooling circuit).
PROBLEM POSSIBLE CAUSES SOLUTION
The device does not
work
The electric plug is not
connected or is loose. The fuse
has blown or is faulty. The
plug is defective.
Insert the electric plug.
Check the fuse.
Replace if necessary.
Operating faults must be
repaired by an electrician.
The appliance freezes
too much.
The temperature adjustment
is too cold or the appliance is
operating on the MAX. setting.
Turn the temperature
regulator temporarily to a
warmer setting.
The food is not
sufficiently frozen.
The temperature is not
properly adjusted. The door
has been left open for an
extended period.
A large amount of warm
food has been placed in the
appliance during the past 24
hours. The appliance is near a
heat source.
Please consult the Adjusting
the initial temperature section.
Only open the door for as long
as is necessary.
Turn the temperature
regulator temporarily to a
colder setting.
Please consult the Installation
position.
Significant
accumulation of ice on
the door seals.
The door seal is not airtight. Carefully heat the unstuck
sections of the door seal with
a hair-dryer (on a cold setting).
At the same time, shape the
heated door seal in your hand
so that it can be correctly
positioned.
Uncommon noises. The appliance is not level.
The appliance is touching the
wall or other items.
Readjust the feet.
Move the appliance slightly.
The side panels are
warm.
This is a normal phenomenon. The heat exchanger parts are
located underneath the side panels.