VALBERG 981456, Инструкция по эксплуатации

Страница: 30 / 124

28 EN
Problem Check whether / Possible cause
Final spin results are poor. The washing machine has an imbalance detection and
correction system. If individual heavy items are loaded
(e.g. bathrobes), this system may reduce the spin speed
automatically or even interrupt the spin completely if it
detects too great an imbalance even after several spin
starts, in order to protect the washing machine.
• If the laundry is still too wet at the end of the cycle,
remove some articles of laundry and repeat the spin
cycle.
• Excessive foam formation may prevent spinning. Use
the correct amount of detergent.
• Check that the spin speed selector has been set to
“ 0 ”.
Enter the after-sales query mode
1. In the OFF mode, press the «Temp.» + «Options» + switch the « » to enter the after-
sales inquiry mode.
2. It displays the number of operation cycles.
3. Press «Options» to switch cycles or fault codes.
4. When querying fault codes, press the «Temp.» to page up and the «Spin» to page down.
5. Turn the knob to «OFF», wait for 3 seconds, you will exit query mode.
Ensure that:
• All connections are tightly fixed.
• Do not allow children to operate, crawl on, be near or inside your washer.
• Note that during the wash cycles, the surface temperature of the porthole
door may increase.
• Close supervision of children is necessary when the appliance is used near
children.
Error code
Fault Code List
Displayed on Display Window Fault Description
“F01” Water inflow fault
“F03” Drainage fault
“F04”, “F05”, “F06”, “F07”,“F23” and
“F24”
Electronic module fault, overflow or too
much foam.
“F13” Door lock fault
“F14” Door unlock fault
“Unb” Unbalance alarm
Cleaning and maintenance
C