Vaisala WXT520, Руководство пользователя

Страница: 42 / 171

User’s Guide ______________________________________________________________________
40 __________________________________________________________________ M210906EN-C
0803-048
Figure 17 Grounding Jumper Location
To remove the jumper, you must open the transmitter. If you need to
access the screw terminals, you should remove the jumper at the same
time.
1. Loosen the three long screws at the bottom of WXT520.
2. Pull out the bottom part of the transmitter.
3. Remove the grounding jumper from the PCB.
4. Replace the bottom part and tighten the three screws. To make sure
that the radiation shield stays straight, do not tighten the screws all
the way in one go. Do not overtighten.
The following numbers refer to Figure 17 on page 40 :
1 = Grounding jumper (remove for marine applications)