Installation
We strongly recommend that you install the unit in an easily accessible location, so you can later upgrade
the unit or re-program it in case of incorrect programming.
IMPORTANT
i
@
Gain access to the back of you vehicle’s Head Unit.
@
Find the same port as our Audio Harness (see
“Connecting MultiMediaLinQ to head unit”
)
@
Disconnect the existing connector (if present) and plug in our Audio connector into this port, then plug female end of
Audio Harness to the plug in for your factory connector. Audio harness female connector is not used in some vehicles
(isolate this connector by using sticky foam tape or electrical tape).
@
Plug the other end of Audio cable into designated port on MultiMediaLinQ.
@
Setup USB Emulation Mode for this unit (see
“USB Emulation Mode Selection”
)
@
Turn the car on and check MultiMediaLinQ functionality before the final assembly.
@
Make sure your USB Storage device or iPod has at least two Folders/playlists, in order for this unit to operate
properly.
@
Please mount this unit in an easy accessible location for upgrading.
@
Do not plug iPod USB cable directly to the MultiMediaLinQ. Use USB 2.0 certified extension cable.
@
Secure the Head Unit in its original position.
Installation
7
USB Emulation Mode Selection (USB emulation)
USB Emulation Mode programming steps:
@
Properly install VML player.
@
Put the “Left” programming switch in the “DOWN” position.
@
Put ignition switch into the “ACC” position.
@
Wait for a long beep followed by a few short beeps. This may take up to one minute.
@
Return programming switches to their default position (both switches “UP”).
Wait up to 30 seconds until confirmation beep.
@
Put ignition switch into the “OFF” position.
@
Wait at least 10 seconds.
@
Put ignition switch into “ACC” or “ON” position.
@
Check MultiMediaLinQ for functionality.
Ignition into
“ACC” or “ON”
position
Both
switches
“UP”
Ignition into
“OFF” position
up to 30 sec
Confirmation beep
Left
switch
“DOWN”
Used for
programming
Power and Audio
wiring harness
Service
Port
USB 2.0 Host
Top cover with
VAIS Technology
Logo
