Installation
4
!
!
Improper Emulation Mode setting may cause this unit to be unrecognized by the head unit.
CD-MP3 Changer Emulation Mode Programming MUST BE DONE in order for the unit to find the proper address
location in the vehicle Audio/Video network.
CD-MP3 Emulation Mode programming steps:
Properly install VML player.
Put the “Left” programming switch in the “DOWN” position.
Put ignition switch into the “ACC” position.
Wait for a long beep followed by a few short beeps. This may take up to one minute.
Return programming switches to their default position (both switches “UP”).
Wait up to 30 seconds until confirmation beep.
Put ignition switch into the “OFF” position.
Wait at least 10 seconds.
Put ignition switch into “ACC” or “ON” position.
Check SoundLinQ for functionality, especially TEXT capabilities.
@
@
@
@
@
@
@
@
@
Ignition into
“OFF” position
!
!
!
Velcro Fasteners are not included
VAIS Technology strongly recommends grounding the unit to the car chassis for best results.
Do not use any screws longer than 5mm. Using screws larger then 5mm may damage the PCB board.
WARNING
Confirmation beep
!
up to 30 sec
CD-MP3 Emulation Mode Selection (CD-MP3 emulation)
Both
switches
“UP”
Mounting unit using Velcro fasteners
Ignition into
“ACC” or “ON”
position
IMPORTANT
Left
switch
“DOWN”
i
i
Carpet or car chassis
“Soft” Velcro Fastener
“Hard” Velcro Fastener
VML (MultiMediaLinQ)
M3 x 5mm*
(see note below)
We strongly recommend to Ground VML to the vehicle’s chassis
i
!
!