1 Safety
4
Installation and maintenance instructions eloSTOR plus 0020244342_01
1.2.4 Material damage due to unsuitable
installation surface
The installation surface must be even and
have sufficient load-bearing capacity to sup-
port the operating weight of the product. An
uneven installation surface may cause leaks
in the product.
There is a risk of death if the connections are
subject to leaks.
▶
Make sure that the product is positioned
flush against the installation surface.
▶
Ensure that the installation surface has
sufficient load-bearing capacity to bear the
operating weight of the product.
1.2.5 Risk of being burned or scalded by
hot components
▶
Only carry out work on these components
once they have cooled down.
1.2.6 Risk of scalding and material
damage due to escaping hot or cold
water
▶
If you use plastic pipes for the hot or cold
water connection of the product, you must
only use pipes that are temperature-res-
istant up to 95 °C under a pressure of 1.0
MPa (10 bar).
1.2.7 Risk of material damage caused by
using an unsuitable tool
▶
Use the correct tool to tighten or loosen
screw connections.
1.2.8 Risk of material damage caused by
frost
▶
Do not install the product in rooms prone
to frost.
1.2.9 Risk of material damage due to high
water pressure.
Excessive water pressure may lead to dam-
age to the water pipes.
1.2.10 Material damage due to leaks
▶
Ensure that there is no mechanical tension
on the supply lines.
▶
Do not suspend any loads from the
pipelines (e.g. clothing).
▶
If there are leaks in the water pipe
between the product and draw-off points,
close the cold water stop valve immedi-
ately.
▶
Have the leak repaired by a competent
person.
1.3
Regulations (directives, laws,
standards)
▶
Observe the national regulations, stand-
ards, guidelines and laws.
