Vaillant ecoTEC pure VC 146/7-2(E-DE), Инструкция по установке и обслуживанию

Страница: 8 / 48

4 Set-up
8
Installation and maintenance instructions ecoTEC pure 0020258016_01
3.2 Information on the identification plate
The identification plate is mounted on the underside of the
product in the factory.
The identification plate keeps record of the country in which
the product is to be installed.
Information on the
data plate Meaning
Condensing techno-
logy Efficiency class of the boiler in accord-
ance with EC Directive 92/42/EEC
Serial number For quality control purposes; 3rd and 4th
digits = year of production
For quality control purposes; 5th and 6th
digits = week of production
For identification purposes; 7th to 16th
digits = product article number
For quality control purposes; 17th to 20th
digits = place of manufacture
... ecoTEC ... Product designation
Cat. Approved gas category
Type: Xx3(x) Permissible flue gas connections
2H / 2E / 3P / 2K... Gas group and gas connection pressure
as set at the factory
Tmax Max. flow temperature
PMS Maximum water pressure in heating
mode
NOx NOx class for the product
V
Hz Electric connection
W Max. electrical power consumption
IP Protection class
Code (DSN) Specific product code
Heating mode
Q n Nominal heating load range in heating
mode
P n Nominal heat output range in heating
mode
P nc Nominal heat output range in heating
mode (condensing technology)
Hot water generation
Q nw Nominal heating load range in domestic
hot water mode
P nw Nominal heat output range in domestic
hot water mode
D Specific flow rate
PMW Maximum water pressure in domestic hot
water mode
Barcode with serial number
Note
Make absolutely sure that the product is compat-
ible with the gas group at the installation site.
3.3 Serial number
The serial number can be found on a plastic label at the bot-
tom of the front casing and on the identification plate.
3.4 CE label
The CE label shows that the products comply with the basic
requirements of the applicable directives as stated on the
identification plate.
The declaration of conformity can be viewed at the manufac-
turer's site.
4 Set-up
4.1 Unpacking the product
1. Remove the product from its box.
2. Remove the protective film from all parts of the product.
4.2 Checking the scope of delivery
▶
Check that the scope of delivery is complete and intact.
4.2.1 Scope of delivery
Num-
ber
Designation
1
Heat generator
1
Bag with accessories:
–
Unit mounting bracket
–
Bag with seals
–
Bag with bolts and rawl plugs
–
Mounting template
–
Flexible condensate discharge pipe
–
Hose set
–
Gas cock
1
Enclosed documentation