Vaderstad Spirit StripDrill ST 600C Series, Инструкция по эксплуатации

Страница: 21 / 38

ST 400-600C StripDrill
01.03.2014 2 21
1.10 Switching between oilseed and grain
When switching from the setting for oilseed to the setting for grain and transport, you must remember that
the furrow must be moved 8 cm to the side when drilling oilseed so as to centre the machine and then re-
adjusted before drilling grain and transport.
When drilling oilseed, the front tool’s drawbar (A) must be in position 1 (
”Figure 1.16”
). Remember that
when drilling oilseed the outermost, long, coulter does not drill. When drilling grain, the front tool’s
drawbar (A) must be in position 2 (
”Figure 1.17” ).
1.10.1 Drilling grain
When drilling grain, the rows must be 16.7 cm apart. Ensure that all outputs in the seed distributor head
are open.
Switching from drilling oilseed to drilling grain and transport
To centre the machine for drilling grain and for transport, the drawbar must be moved 8 cm to the side and
be in position 2. See
”Figure 1.17”
.
1 Place the drawbar (A) in position 2. See ”Figure 1.17” .
2 Remove the spacer (B) from the front tool ( ”Figure 1.18” ).
3 Slide the front tool over to the other end position.
4 Fit the spacers (B) to the other side of the bolts.
Figure 1.18 From drilling oilseed to drilling grain
A
A
Figure 1.16 Position 1 Figure 1.17 Position 2
B
B