CLIO Service Manual
CLIO Tear-down & Rebuild
11.
Insert and secure the six K2.2x7 Torx screws (38) in the Keyboard Base Bottom using a
#6 Torx head screwdriver torqued to 0.2N.M.
12.
Insert and secure an M3x6 screw (37) in the hole in the lower left corner of the Keyboard
Base Bottom using a #2 Phillips head screwdriver torqued to 0.4N.M
13.
Replace the two rubber feet in the far left and right-hand corners of the Keyboard Base
Bottom (31).
14.
Follow the ROM/RAM Cover Refit procedure (above).
15.
Follow the Battery Pack Cover procedure (above).
5.9. CLIO
K
EYBOARD
B
ASE
T
OP
-
R
EMOVE AND
R
EFIT
Please refer to photos 4-16, 22 in Chapter 2.
5.9.1. CLIO
K
EYBOARD
B
ASE
T
OP
R
EMOVAL
1.
Place the CLIO unit on a flat level work surface in standard orientation.
2.
Follow the Keyboard Base Bottom removal procedure, above.
3.
Using tweezers or a pair of miniature needle-nosed pliers, gently lift the Indicator PWB
Unit (51, 52) from its slot by lifting it straight up. The Indicator PWB Unit (51, 52) is the
small PWB located in the center of the CLIO’s front side (facing away from you) with the
insulator attached to the back side of the board. Take care not to bend or break the
delicate soldered connection between the Indicator PWB Unit (51, 52) and the ribbon
cable (53) connected to it.
4.
Using fingernails, reach under the left and right sides of the Keyboard Unit (40)(silver
metal plate) and gently lift it approximately five millimeters to separate it from the
Keyboard Base Top (47). Use extreme caution to avoid bending or breaking the
Indicator PWB Unit ribbon cable (53) or the keyboard ribbon cable connectors.
5.
With your right hand, grasp the keyboard assembly (40) gently but firmly. With your left
hand, grasp the Main PCB Unit (50) gently but firmly. In unison, lift the two assemblies
straight up and out of the Keyboard Base Top (47), taking care to avoid over-extending
the two flex circuits (8). Rotate the two assemblies clockwise 90 degrees and place them
on the work surface.
6.
Remove the protective plastic mat from the Keyboard Base Top (47) and store it in a
secure location.
7.
Ensure that the Bottom Hinge (43, 44) is removed from the Keyboard Base Top (47).
Refer to the Lower Hinge Remove & Refit procedure (below).
8.
The Keyboard Base Top (47) may now be picked up and stored in a secure location.
5.9.2. CLIO
K
EYBOARD
B
ASE
T
OP
R
EFIT
1.
The LCD Unit (66) should be lying on the work surface in standard orientation (screen
up,
{On/Suspend}
button on the right). The Main PWB Unit (50) and Keyboard Assembly
(40) should be resting on the work surface at approximately right angles to the LCD Unit
(66). Both assemblies should be upside-down (keyboard assembly should have a silver
5-6
The information contained in this document is confidential and the sole property of Vadem Inc. Written
permission must be obtained to reprint or use any of this information.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - [email protected]
