GroupSTATION
Vaddio GroupSTATION - Document Number 342-0671 Rev A
Page 18 of 40
Option: Using the PC to MicPOD Dock Accessory Cable:
The GroupSTATION has a Premium 3’ (.91m) 4x4 Interface Cable PC to Dock accessory cable that combines the
Ethernet, HDMI, VGA, and USB cables into a single fan-out assembly to simplify cable management between the
MicPOD Dock and PC.
Image: PC to MicPOD Dock Cable Accessory
Step 6: Initial System Power Up
Once the PC is on and connected properly, plug the Camera/Sound Bar’s power supply’s AC cord into an AC wall
outlet. The unit will initialize and the OSD will display “Initializing” and prepare for operational use. The green
LED next to power button will light up.
When the system is finished initializing, the OSD will display the
IP
a
MAC
addresses for 20 seconds.
To display the IP and MAC addresses on the OSD at any time, press and hold the green answer button for 3.0seconds
and the IP and MAC addresses will be displayed for 20 seconds.
It is most probably a good idea to write the address down. Otherwise, the default IP address of the
GroupSTATION is 169.254.1.1 and can be accessed via its internal web pages. Remember, always involve the
IT department personnel for interfacing with any LAN/WAN. The network professionals will know how to set-up
the IP addresses in Static or DHCP modes as well as the VoIP functionality. Reinvention of the wheel is not
required.
Image: Press and Hold Multifunction Buttons (PHMB)
There are three (3) PHMBs on the MicPOD Dock that have
dual functions. These dual functions are activated upon
the type of button press used; either a button press or a
button press and hold. Each of these buttons has an LED
by it and they are as follows:
1) Answer (Send) Button:
a.
A button press
answers inbound calls from VoIP or
USB, or it sends a dialed number to the VoIP PBX.
b.
Press and hold
for 3.0 seconds to display the IP and
MAC addresses on the OSD, for 20 seconds.
2) Hang-up (Disconnect Button):
a.
A button press
disconnects a VoIP call. The Red LED
flashes once to indicate the call was terminated.
b.
Press and hold
the red Hang-up button for 5.0 seconds
for a Factory Reset,. The system will provide a prompt
on the monitor. When the prompt is answered the
system will begin to reset, please don’t interrupt a reset.
3) On/Off
Power
Button
.
a.
A button press
turns the system on. The green LED is illuminated when the system is on.
b.
Press and hold
the Power button for 3.0 seconds and the system will enter Standby Mode. In the off position, USB
audio/video ins and outs as well as VoIP functions are disabled and unit is in Standby. Standby Mode is indicated on
the OSD.
➊
➋
➌
